Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
piep:examples:ledswitch [2019/04/12 16:33]
jonathan
piep:examples:ledswitch [2019/04/16 00:54] (current)
venkat
Line 32: Line 32:
  
  
-Before working on this example, make sure you have set the latest **KoliadaESDK**. More information on setSDK setup and setting the path is shown [[kes:​software:​koliadaes_sdk|here]]. ​+Before working on this example, make sure you have set the latest **KoliadaESDK<​sup>​(TM)</​sup>​**. More information on setSDK setup and setting the path is shown [[kes:​software:​koliadaes_sdk|here]]. ​
  
 **Note:** After making sure SDK path is set, you must know that the board config must be flashed only if you are using any I/O pins. In this particular example there are  I/O configurations for the LED and Switch and hence you should open the LEDSwitch config project in visual studio. You can find the project under koliadaSDK->​examples->​LEDSwitchConfig. **Note:** After making sure SDK path is set, you must know that the board config must be flashed only if you are using any I/O pins. In this particular example there are  I/O configurations for the LED and Switch and hence you should open the LEDSwitch config project in visual studio. You can find the project under koliadaSDK->​examples->​LEDSwitchConfig.
      Copyright © 2018-2019 Koliada, LLC
  • piep/examples/ledswitch.txt
  • Last modified: 2019/04/16 00:54
  • by venkat